Red Alert!…System Failure
from The Septic System Owner's Manual
Your system has failed that’s presumably why you’re reading this chapter. Water has backed up into the shower, the toilets won’t flush, and/or drains won’t drain. This means wastewater has backed up from the tank through the main drain into the house. It’s going the wrong way! Or untreated effluent is surfacing on the ground. In this chapter we’ll talk about different types of failures, their causes, and what to do when your system fails.
Probable Causes of Failure
One or more of the following may have happened:
- The sewage pipe between the house and the tank is blocked or broken.
- Either the inlet or outlet tee is blocked or broken.
- The line between the tank and drainfield is blocked or broken.
- If the system has a pump, there may have been an electrical or mechanical failure.
- The tank itself is blocked with solids or has collapsed (an old redwood tank perhaps).
- The drainfield is flooded due to heavy rains or flooding.
- The drainfield is (partially or completely) clogged with solids or roots.
Locating the Problem
When the septic system is failing, there is a procedure for locating the cause, called the discovery process, in which you search for the problem in the following order:
You start by searching for a blockage somewhere in the system because this is the easiest cause to locate, and the easiest (and cheapest) problem to solve.
- If only one fixture does not drain, check for blockage between the fixture and the main drain pipe. Use clean-outs for checking.
- If all fixtures on one branch of the drain pipe do not drain, check for blockage in that branch. Also, check the tank inlet for blockage.
- Open the tank.
- If it is flooded: The problem may be at the outlet or beyond. Check the outlet for blockage.
- If it is not flooded: You can check the various household fixtures by running a hose down them to see if the water makes it to the tank.
- If sewage is not arriving at the tank, then check for a pipe line blockage between the house and the tank.
- If both the outlet and the inlet tees are good, but sewage is still backing up in the tank and house plumbing, the problem may be in the tightline (pipe between tank and drainfield) or the drainfield itself.
- To check the tightline, you’ll have to dig it up where it enters the drainfield. Try a plumber’s snake to check for a blockage between the tank and drainfield. Or, the tightline may be broken or sheared off.
- If the tightline is clear and intact, and all of the above steps have not produced the culprit, the drainfield is probably the problem.
Clearing Pipe Blockage
If the plumbing suddenly backs up under normal use, especially in dry weather, blockage is the prime suspect. This is generally the easiest problem to correct, particularly if it’s between the house and tank.
Most pipe blockages can be located using a plumber’s snake. (All tool rental stores have snakes.) Or, an old garden hose may work if there are not too many bends in the pipe. Also, there is a simple (and brilliant!) rubber device called the Drain King, which fits on the end of a garden hose. The hose is then run down the clogged drain pipe, and when the water is turned on, the bulbous rubber section expands, locks in the pipe, and emits strong pulsating bursts of water. These are available for 1- to 10-inch drains.
If you find that roots between house and tank are the problem, a Roto-Rooter can clear the line, but the roots will return if the entry points (leaks) are not found and sealed.
A common problem is that the tightline (pipe between tank and drainfield) has broken. This often happens when the tank, which is very heavy when filled, has settled in the ground some time after installation, and the pipe has not flexed. (In some areas, new systems now must include a flexible coupling at the septic tank wall.) As with pipe blockage, snaking the line usually helps you find this problem so the pipe can be either repaired or replaced. Sometimes it is easier and cheaper to replace the tightline, especially if roots are the problem, than to try to clear it.
If you have an alternative system that uses electricity to pump the effluent to the drainfield and there is a power outage, the pump chamber should be checked immediately. If it is low, you’re OK, but monitor your water usage. If it is nearly full, water usage must be severely curtailed or the result will be effluent from the pump chamber backflowing into your house since there’s no electricity to pump the effluent to the drainfield a distinct disadvantage to high-tech systems! You’ll have to wait until the electricity comes back on, or keep a small standby generator on hand for such emergencies.
If you live in an area with high groundwater and heavy rains, your tank and your pump chamber might be filling with rainwater runoff. It is wise to have good risers around the inspection holes of the septic tank since concrete lids generally leak. These risers are sold in many builders’ supply outlets.
Every tank has an estimated life span.
Redwood tanks: They can last from 15 to 45 years. Redwood tanks as well as steel tanks are now illegal in many areas. The top and upper sidewalls of a redwood tank will deteriorate first, causing the top to cave in (this can be dangerous, especially for kids) and the tank will start leaking in the upper 6 inches of liquid level. If a redwood tank fails completely, it’s best to replace it with a concrete or fiberglass one. However, if the sidewalls and bottom are good, installing a new top may gain you another 10 years.
Fiberglass tanks: They are light to handle, and quite durable, but they have been known to break due to shifting ground and are hard to repair.
Polyethylene tanks: They sometimes lack structural integrity. Manufacturers claim an estimated life span of 30 years.
Concrete tanks: They are usually precast and are the best and most common type of tanks.
- Concrete tanks can develop leaks if the ground shifts, if the concrete was of poor quality, or (very common), when the joint between top and body leaks. Further:
- The tank may be porous and leak from the start.
- The tank may not be properly sealed and small leaks can grow larger. Leaks can be fixed, but the tank must be properly cleaned and prepared, and techniques are difficult and dangerous in an older tank.
All tanks can leak around the inlet and outlet connections. This can usually be repaired by re-sealing the joints with caulk or mortar. Due to accumulation of gases, concrete outlet connections often disintegrate. Old ones should be replaced with plastic fittings.
Warning:Any underground tank that has had sewage in it is dangerous due to gases, especially if you are working alone. Only a trained professional with a self-contained breathing apparatus should enter a septic tank. Repairs to inlet and outlet tees can usually be completed without entering the tank, and should be done when the tank is pumped.
This is the most serious and costly type of failure. Pipe blockages can be removed. Loose connections can be fixed. A faulty tank can usually be repaired. But if the drainfield is clogged, it must be replaced, a disrupting and costly procedure.
Suspicious Drainfield Behavior
You can suspect the problem is the drainfield if:
- there are odors or persistent wet spots over the field
- the plumbing becomes sluggish over a period of time, or when it’s used heavily, or during wet months
- problems persist even though the tank has been pumped recently
- the septic tank is flooded
Why Do Drainfields Fail?
- Clogging with solids: When a tank has not been pumped periodically, it fills up and eventually the solids migrate out of the tank into the drainfield. Also, old drainfields can be clogged by soil infiltration. Either the perforated distribution pipe or the pores in the soil become clogged.
- Root blockage: Root growth near a septic system is a mixed blessing. The good news is that plant growth over a drainfield will absorb much of the discharge; further, in arid areas, evapotranspiration will release the water back into the environment. The down side is that the same root growth that absorbs water can clog disposal lines and trenches and hinder drainfield function (although root blockage is not the same problem in a shallow drainfield).
- Root deterrent products do kill roots, but we don’t recommend them, any more than we’d recommend putting Drano down the drain. Most of these products contain copper sulfate, or “bluestone,” which can kill off the beneficial organisms in both the tank and the drainfield, and poison things if it gets in the water table. (These products also produce toxins in the manufacturing process.) Far better to snake out the line and then remove the source of the roots.
- High groundwater: When a drainfield is saturated with groundwater, it won’t be able to perform its cleansing action. It’s possible to improve things with better drainage.
Two Degrees of Drainfield Failure
- Partial failure: Here the drainfield will work during dry weather, but with heavy rains (or high household use), the system is overloaded.
- Complete failure: Worst case scenario. Here no remedial steps can be taken with the present drainfield.
Remedies for Partially Failed Drainfields
- Cleaning the distribution pipe in the trench may work if things have not progressed too far. Have it snaked out with a Roto-Rooter.
- If caused by roots, dig up a section and look. Remove invasive trees and plants. Roto-Rooter pipes. Consider removing invasive trees or plants. The drainfield may recover as dead roots decay.
- Cut water usage in half, if possible.
- Improve drainage.
The Distribution Box Solution
Engineer Rick Duncan recommends the following procedure for a saturated drainfield (here professional help is recommended): If there are several drainfield laterals, inspect them to see if they are all being overloaded. If not and if possible, put in a distribution box with flow levellers (or weir inserts). Adjust the levellers so effluent flows mostly to under-utilized lines. The idea is to allow the over-utilized lines to rest and rejuvenate this may take a number of months, depending on local soil and climate.
If all drainfields are saturated, use a larger distribution box, with inserts, and install several replacement lines, leaving the existing lines hooked up as well. Here the old lines are not abandoned and they may be useful after being rested a while.
Note: Concrete distribution boxes tend to deteriorate rather rapidly, especially in acidic soils. High-density, polyethylene D-boxes solve this problem.
Remedies for Completely Failed Drainfields
- Hire a professional to install a new drainfield, or better yet, dual drainfields or a pressure-dosed shallow drainfield.
- Do it yourself if you know what you’re doing. Here you’ll act as the contractor hiring a backhoe, dumptruck for gravel, etc. However, it’s very important that the drainfield be properly designed and installed this isn’t an area for guesswork. Consult local professionals.
If you approach your local health department regarding a drainfield failure, they will often require a much larger drainfield than was originally installed, as well as a larger tank, or, in some cases, an entirely different system (a mound, sand filter, etc., along with the machinery required to run these units). There is, however, an exception, and that is the “repair-as-is” option. This is where the health department will allow you to:
- pump out the tank and ensure that the tank and all connections are functioning properly.
- install a replacement drainfield the same size or larger than the original, or a dual drainfield, or a pressure-dosed shallow drainfield.
This seems to us a desirable alternative, especially if, for instance, the garbage disposal is disconnected and the home residents follow practical daily domestic wastewater practices, as shown in Chapter 4 (pp. 3845). It saves money and materials, is kinder to the environment, conserves energy (gravity power vs. electricity), and is lower maintenance.
Old-Fashioned Muscle Power
We have heard reports of a small town in Southern California where a number of septic systems have been failing in recent years, and the county health department has been requiring high-tech fixes mounds, sand filters, pumps, etc. often costing $20,000$30,000.
An local enterprise has sprung up: a worker has been hand-digging new drainfields, installing pipe, new gravel, and permeable membrane, for a total of around $700. At the same time, the tank is pumped, tees checked and (hopefully) the householders follow the advice in Chapter 4 (pp. 3845) and end up with a few more decades of a functioning system.
Terra-Lift Soil Loosener
This is a machine that uses pneumatic pressure to clear clogged drainfields.
Consulting Regulatory Agencies and Engineers
The above brings up what is often a homeowner’s dilemma a “rock and a hard place” situation. What if a regulatory agency is requiring an upgrade that you cannot afford, yet you are uncomfortable with sidestepping regulations or making the repairs on your own?
There are sound historical reasons for health regulations. A century ago, when much of America was sparsely populated, relatively primitive systems, such as outhouses and cesspools, were widely used. If an unsanitary situation developed, it was confined to the farm or homestead. But as the population grew, as people began living closer together, and as health problems surfaced, regulations were enacted. For good reason.
Worst-Case Agency Scenario
The trouble these days is not with sound health codes, but with what we all may have experienced in one field or another: regulatory overkill. The worst-case scenario is an agency that will not consider anything other than a high-tech septic system. It will not allow the “repair-as-is” option, it will not countenance the standard gravity-fed septic system, nor is it open to new, lower cost solutions such as the recirculating gravel filter, or shallow pressure-dosed drainfields. The agency may even have a list of engineers that a homeowner must choose from.
Worst-Case Homeowner’s Scenario
The worst-case scenario in owner-installed or owner-fixed systems can be substandard, useless, or even dangerous repairs that can lead to civil or even criminal (!) action. Septic system design is not rocket science, yet neither is it simple or straightforward on many sites. Many systems fail because they are improperly designed and/or installed. Fixing a failed drainfield may be either simple and functional, or, if improperly done, a waste of time and materials. Another factor, of special interest if you are considering selling your home, has surfaced (sic) in recent years: Sellers have been sued for non-disclosure after the sale of a home and subsequent septic system failure. Seller beware!
What’s a poor homeowner to do? The homeowner may want to step out of the agency/engineer/contractor loop and participate in some or all of the functions of fixing an ailing system. It would be ideal if you were able to consult with the regulatory agency, which would be in turn open to owner-controlled repairs, subject to inspection. Often, officials will help homeowners with guidance and advice. Additionally, the services of a professional septic systems engineer can be invaluable. Although a standard septic tank and its connections are not hard to understand, its placement, the hydrological capacity of the soil, and the type and placement of the drainfield are factors where professional help is often the difference between success and failure.
We can’t tell you what to do, but we hope we can make you aware of options and the range of consequences. Very often, officials will be open to a positive, well-researched owner approach. An engineer may be willing to work with you to solve your problems within your budget, telling you what functions you may perform yourself.
copyright © 2007 - Shelter Publications, Inc.